Qinq Commands; Display Qinq - HP FlexNetwork 5130 HI series Command Reference Manual

QinQ commands

This document uses the following terms:
•
CVLAN—Customer network VLANs, also called inner VLANs, refer to VLANs that a customer
uses on the private network.
•
SVLAN—Service provider network VLANs, also called outer VLANs, refer to VLANs that a
service provider uses to transmit VLAN tagged traffic for customers.

display qinq

Use display qinq to display the QinQ-enabled interfaces.
Syntax
display qinq [ interface interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface interface-type interface-number: Specifies an interface by its type and number. If you do
not specify an interface, this command displays all QinQ-enabled interfaces.
Usage guidelines
If QinQ is not enabled on any interfaces, this command does not provide any output.
Examples
# Enable QinQ on GigabitEthernet 1/0/1. Then, verify that QinQ is enabled on the interface.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qinq enable
[Sysname-GigabitEthernet1/0/1] display qinq interface gigabitethernet 1/0/1
Interface
GigabitEthernet1/0/1
# Enable QinQ on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/3. Then, verify that QinQ is enabled
on the interfaces.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qinq enable
[Sysname-GigabitEthernet1/0/1] quit
[Sysname] interface gigabitethernet 1/0/3
[Sysname-GigabitEthernet1/0/3] qinq enable
[Sysname-GigabitEthernet1/0/3] display qinq
Interface
GigabitEthernet1/0/1
GigabitEthernet1/0/3
241