Group Alarms; Applying The Function Parameter Settings - Siemens SIPROTEC 7SA6 Manual

Functions

6.21.1.6 Group Alarms

6.21.2 Applying the Function Parameter Settings

6-286
Certain messages of the monitoring functions are already combined to group alarms.
Table 6-14 shows an overview of these group alarms an their composition.
Table 6-14 Group alarms
Group alarms
FNo Designation
161 Fail I Superv.
164 Fail U Superv.
160 Alarm Sum Event
140 Error Sum Alarm
1
) depending on the version (number of printed circuit boards)
The sensitivity of the measured value monitoring can be changed. In the factory, pre-
settings based on experience have already been applied, which should be sufficient
for most applications. If particularly high operational asymmetries of the currents and/
or voltages are expected, or if one or more monitoring functions pick up sporadically
during normal operation, the sensitivity setting(s) should be reduced.
In address 2901 MEASURE. SUPERV the measured value monitoring can be switched
ON or OFF .
Composed of
FNo Meaning
Fail ΣI
162
163 Fail I balance
Fail ΣUphe
165
167 Fail U balance
168 Fail U absent
Fail ΣI
162
163 Fail I balance
Fail ΣUphe
165
167 Fail U balance
168 Fail U absent
169 VT Fuse fail > 10 s
170 VT FuseFail
361 >Fail:Feeder VT
171 Fail Ph.Seq.
177 Fail battery
193 Alarm NO calibr
3464 Topol complete, negated
183 Error Board 1
1
184 Error Board 2 )
1
185 Error Board 3 )
1
186 Error Board 4 )
1
187 Error Board 5 )
1
188 Error Board 6 )
1
189 Error Board 7 )
144 Error 5V
168 Fail U absent
192 Error 1A/5A wrong
194 Error neutral
181 Error A/D-conv.
C53000-G1176-C156-2
7SA6 Manual