Table of Contents
Advertisement
Installation and Commissioning
o
8-26
X73
(AD2)
X72
(AD1)
X71
(AD0)
H
L
Bild 8-15 Input/output module C–I/O–10 with representation of the jumper settings required
for the module configuration
Depending on the device version the contacts of some binary outputs can be changed
from from normally open to normally closed operation (see also in Appendix, Section
A.2).
∗
∗
With version 7SA6
1
–
binary output BO9 (Figure 8-10, slot 19);
∗
∗
With version 7SA6
2
–
binary output BO9 and BO17 (Figure 8-11, slot 33 left und slot 19 right);
∗
∗
With version 7SA6
2
–
binary output BO9, BO17 and BO25 (Figure 8-11, slot 33 left, slot 19 right und slot 19
left);
∗
∗
With version 7SA6
2
–
binary output BO17 (Figure 8-11, slot 19 right);
1
∗
A / E / J (housing size
/
1
∗
A / E / J (housing size
/
1
∗
B / F / K (housing size
/
1
∗
M / P / R (housing size
with 16 binary outputs) this goes for
2
with 24 binary outputs) this goes for
1
with 32 binary outputs) this goes for
1
/
with 24 binary outputs) this goes for
1
C53000-G1176-C156-2
7SA6 Manual
Advertisement
Table of Contents
