Self-Test Page; Product Information Page; Communication Status Page - GE D90 Plus Instruction Manual

ANNUNCIATOR

Self-test page

Product information page

Communication status page

78
This page displays any active self-test alarms as well as the time of occurrence and the
severity of the alarm (yellow for non-critical and red for critical).
The product information page contains data describing the device, including the order
code, serial number, device identification name, setting configuration name, time of last
change, firmware version, and firmware release date.
Figure 59: Sample product information page
The Relay ID value reflects the string entered as the
Protection > Power System > Installation menu. The
string entered as the
User Configuration Name
System > Installation menu. The setup program automatically updates the
Date after each setting change. The current D90
annunciator pages, as does the total number of active self-tests and alarms.
This page outlines the available TCP/IP connections for the supported protocols and the IP
addresses of the ports used.
Plus
The D90 supports up to five Manufacturing Message Specification (MMS) connections,
four Modbus connections, two Distributed Network Protocol (DNP) connections, and one
Phasor Measurement Unit (PMU) connection. The DNP connections are shown as available
if the protocol has been enabled and the D90
Figure 58: Self-test page example
Relay Name
Configuration
in the Settings > Protection > Power
Plus
date and time display on all
Plus
restarted.
PLUS
D90 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 4: FRONT PANEL INTERFACE
in the Settings >
value reflects the
Configuration