GE D90 Plus Instruction Manual page 127

CHAPTER 6: COMMUNICATIONS
PLUS
D90 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
Figure 95: Fixed GOOSE transmission configuration settings
The following settings are available.
Function
Range: Enabled, Disabled
Default: Disabled
This setting enables and disables fixed GOOSE transmission.
ID
Range: up to 65 ASCII characters
Default: GOOSEOut
This setting represents the IEC 61850 GOOSE application ID (GoID) name string sent as
part of each GOOSE message. This name string identifies the GOOSE message to the
receiving device.
Destination MAC
Range: standard MAC address format
Default: 00 00 00 00 00 00
This setting specifies the destination Ethernet MAC address for the fixed GOOSE
transmission. This address must be a multicast address and the least significant bit of
the first byte must be set.
If this setting is specified as "00 00 00 00 00 00" (the default value), then a multicast MAC
address is formed based on the MAC address of Ethernet ports 2 and 3. The MAC address
of Ethernet port 2 is the MAC address of Ethernet port 1 incremented by 1. The MAC
address of Ethernet port 3 is the MAC address of Ethernet port 1 incremented by 2.
GOOSE VLAN Priority
Range: 0 to 7 in steps of 1
Default: 4
This setting indicates the Ethernet priority of GOOSE messages. This allows GOOSE
messages to have higher priority than other Ethernet data. This setting is required by IEC
61850.
GOOSE VLAN ID
Range: 0 to 4096 in steps of 1
Default: 0
This setting allows the selection of a specific VLAN ID for each GOOSE sending device.
This value can be left at its default if the feature is not required.
IEC 61850 COMMUNICATIONS
117