Connect For First Time With Quick Connect - GE D90 Plus Instruction Manual

INSTALL SOFTWARE

Connect for first time with Quick Connect

62
Figure 41: UR
The most convenient way to establish communication to the D90
Plus
the EnerVista UR Setup software is to use the USB interface located on the front of the
relay. Once communications has been established the settings for the RS485 and Ethernet
port can then be configured as described in the following sections. This procedure
assumes the EnerVista UR
1. Ensure that the USB cable is not connected to the D90
Plus
2. Start EnerVista UR
3. Connect the USB cable between the computer and the front panel of the D90
Plus
-series device added to Launchpad window
Plus
Setup software has been installed.
Setup software.
PLUS
D90 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 3: INSTALLATION
Plus
for the first time using
Plus
.
Plus
.