Remote Operation; Remote Run (Command: 1001) - Mitsubishi Electric MELSEC IQ-R series Reference Manual

11.2

Remote Operation

Change the operation status of CPU module.
For the remote operation function, refer to the manual of each CPU module.
• When powering OFF to ON or resetting the access target CPU after applying remote RUN/STOP/PAUSE,
the information of the remote operation will be cancelled. After powering OFF to ON or resetting CPU, the
CPU operates with the status of the switch on the CPU module.
• When the system protection of the access target module is enabled, the remote operation cannot be
performed and an error response will be returned. Disable the system protection of the CPU module.
• For E71, the communication using UDP/IP is recommended. For the communication using TCP/IP, re-
establishment of the connection is required because the connection is disconnected at resetting CPU
module.
• One communication of command provides remote operation for 1 station.

Remote RUN (command: 1001)

Perform remote RUN for the access target module.
The command can be executed when the switch of the access target module is RUN. In the STOP status, the
command is completed normally, however, the access target CPU will not be in RUN status.
Message format
The following shows the message format of the request data and response data of the command.
■Request data
Command Subcommand
■Response data
There is no response data for this command.
Fixed
Mode Clear mode
values
11 CONTROL MODULE OPERATION
11.2 Remote Operation
11
173