Remote Operation Function - Mitsubishi Electric MELSEC Q Series User Manual

11.5

Remote Operation Function

The remote operation function controls the operation status of the C Controller module or a programmable controller
CPU from the user program or Setting/monitoring tools for the C Controller module.
Use the dedicated function library for control by the user program.
There are the following three different remote operations.
• Remote RUN/STOP (Page 163, (1) in this section)
• Remote PAUSE ( Page 165, (2) in this section
• Remote RESET ( Page 166, (3) in this section)
• Restarting user CPU ( Page 73, Section 6.4)
For the remote operation, refer to the manual for the programmable controller CPU.
(1) Remote RUN/STOP
The remote RUN/STOP is a control from Setting/monitoring tools for the C Controller module, by which the C
Controller module can run or stop with its RUN/STOP/MODE switch set to RUN.
(a) Application
The remote RUN/STOP is useful when:
• The C Controller module is out of reach.
• External signals are used to run or stop the C Controller module inside a control panel.
(b) Operation
The remote RUN/STOP makes the C Controller module behave as described below.
• Remote STOP
As soon as remote STOP is requested, the C Controller module is stopped.
( Page 307, Section 17.2.3 (2))
• Remote RUN
Executing remote RUN in the remote STOP status will change the C Controller module status to RUN
again. ( Page 307, Section 17.2.3 (1))
Note11.4
Q24DHCCPU-LS
Q24DHCCPU-LS and Q26DHCCPU-LS cannot be set by user programs.
Q26DHCCPU-LS
CHAPTER 11 BASIC FUNCTIONS
Q24DHC-V Q24DHC-VG Q24DHC-LS
Note11.4
Note11.4
Q26DHC-LS Q12DC-V
11
163