Table of Contents
Advertisement
LANCOM ES-2126+ and LANCOM ES-2126P+
Chapter 4: Operation of Web- based Management
4.11.1
Port Setting/Status
Port setting/status is used to configure the trunk property of each and every
port in the switch system.
94
Per Trunking Group supports a maximum of 4 ready member-ports. Please
note that some decisions will automatically be made by the system while
you are configuring your trunking ports. Trunk Setting Rules are listed
below:
Rule1:Maximum 3 groups are allowed
Rule 2: The members of each group cannot exceed more than 4 ports
Rule 3: Group 1 and 2 cannot exist member 25 and 26 port
Rule 4: Group 3 cannot exist member from 1 to 24 port
Parameter Description:
Method: This determines the method a port uses to aggregate with
other ports.
None: A port does not want to aggregate with any other port
should choose this default setting.
LACP: A port use LACP as its trunk method to get aggregated with
other ports also using LACP.
Static: A port use Static Trunk as its trunk method to get aggrega-
ted with other ports also using Static Trunk.
Group: Ports choosing the same trunking method other than "None"
must be assigned a unique Group number (i.e. Group ID, valid value
is from 1 to 8) in order to declare that they wish to aggregate with
each other.
Active LACP:
This field is only referenced when a port's trunking method is LACP.
Active:
An Active LACP port begins to send LACPDU to its link partner
right after the LACP protocol entity started to take control of this
port.
Passive:
A Passive LACP port will not actively send LACPDU out before it
receives an LACPDU from its link partner.
Advertisement
Table of Contents
