Table of Contents
Advertisement
LANCOM ES-2126+ and LANCOM ES-2126P+
Chapter 4: Operation of Web- based Management
4.23
Reboot
We offer you many ways to reboot the switch, including power up, hardware
reset and software reset. You can press the RESET button in the front panel to
reset the switch. After upgrading software, changing IP configuration or
changing VLAN mode configuration, then you must reboot to have the new
configuration taken effect. Here we are discussing is software reset for the
"reboot" in the main menu.
Reboot
134
2. Specifying what the filename and where the file is. You must specify full
path and filename.
Then, press <Upgrade> button if your download is not successful, the
switch will also be back to "Software Upgrade", and it will not upgrade
the software as well.
When download is completed, the switch starts upgrading software. A
reboot message will be prompted after completing upgrading software.
At this time, you must reboot the switch to have new software worked.
Note: Software upgrade is hazardous if power is off. You must do it care-
fully.
Parameter Description:
TFTP Server: A TFTP server stored the image file you want to upgrade.
Path and Filename: File path and filename stored the image file you
want to upgrade.
Function Description: Reboot the switch. Reboot takes the same effect as
the RESET button on the front panel of the switch. It will take around thirty
(30) seconds to complete the system boot.
Parameter Description:
Advertisement
Table of Contents
