Table of Contents
Advertisement
3.1.2
Starting the Command Line Interface over the network
If you know the device's IP address (see section above) and the LANCOM
switch is accessible from your computer via the network, the you can use the
command line interface via the network.
³
To do this, start a console such as Telnet and enter the device's IP address
as the target.
·
Log on with user name and password (default: admin, admin).
3.1.3
Starting the Command Line Interface over the serial connection
If you do not know the IP address of the device, you can use the command
line interface via a serial connection.
³
Use the serial configuration cable to connect the LANCOM switch to the
configuration computer (→"Mounting and connecting up the LANCOM
Switch').
·
Start a terminal program on the configuration computer, such as Hyper-
terminal under Windows. Use the following parameters for the connec-
tion:
Baud rate: 115200
Stop bits: 1
Data bits: 8
Parity: N
Flow control: None
LANCOM ES-2126+ and LANCOM ES-2126P+
Chapter 3: Configuring and monitoring the LANCOM switch
23
Advertisement
Table of Contents
