Save/Restore - Lancom ES-2126+ Manual

This is the default configuration and it cannot be altered. The web user
interface has the following options to restore the switch to its default
setting.
With the function "restore default configuration included default IP
address" you can reset the switch to the factory default settings
(including the administrator´s password and the auto DHCP setting).
With the function "restore default configuration without changing
current IP address" you can reset the switch to the factory default set-
tings, but without changing the IP address. You can access the switch
at its last IP address.
With the serial configuration interface you can reset the switch to the
factory default setting, without knowing the current administrator´s
password. To do this you have to set up a serial connection to the
device as described in →'Start Command Line Interface via serial
connection'. In the terminal program, before you enter the username
press CTRL+Z, enter "RESET" as the username and the MAC address
(without blank characters) as the password.
This action starts the reset process and all settings will be reset to the

factory default state, including the administrator´s password and the
auto DHCP setting.
3.2.1

Save/Restore

Save as start configuration
Here you can save your current configuration to the flash memory as a
start configuration.
Save as user configuration
LANCOM ES-2126+ and LANCOM ES-2126P+
Chapter 3: Configuring and monitoring the LANCOM switch
25