Lancom ES-2126+ Manual page 47

LANCOM ES-2126+ and LANCOM ES-2126P+
Chapter 4: Operation of Web- based Management
46
will be automatically refreshed the port current status about every 5
seconds.
Parameter:
Port No: Display the port number. The number is 1 – 26. Both port 25
and 26 are optional modules.
Media: Show the media type adopted in all ports. The Port 25 and Port
26 are optional modules, which support either fiber or UTP media with
either Gigabit Ethernet (1000Mbps) or 10/100Mbps Fast Ethernet
port. They may have different media types and speed. Especially, fiber
port has comprehensive types of connector, distance, fiber mode and
so on. The switch describes the module ports with the following page.
Link: Show that if the link on the port is active or not. If the link is con-
nected to a working-well device, the Link will show the link "Up";
otherwise, it will show "Down". This is determined by the hardware
on both devices of the connection.
No default value.
State: Show that the communication function of the port is "Enabled"
or "Disabled". When it is enabled, traffic can be transmitted and
received via this port. When it is disabled, no traffic can be transferred
through this port. Port State is configured by user.
Default: Enabled.
Auto Nego.: Show the exchange mode of Ethernet MAC. There are
two modes supported in the switch. They are auto-negotiation mode
"Enabled" and forced mode "Disabled". When in "Enabled" mode,
this function will automatically negotiate by hardware itself and
exchange each other the capability of speed and duplex mode with
other site which is linked, and comes out the best communication
way. When in "Disabled" mode, both parties must have the same set-
ting of speed and duplex, otherwise, both of them will not be linked.
In this case, the link result is "Down".
Default: Enabled
Speed / Duplex : Display the speed and duplex of all port. There are
three speeds 10Mbps, 100Mbps and 1000Mbps supported for TP
media, and the duplex supported is half duplex and full duplex. If the
media is 1Gbps fiber, it is 1000Mbps supported only. The status of
speed/duplex mode is determined by 1) the negotiation of both local