Table of Contents
Advertisement
4.9.8
Config
GVRP Config
In the function of GVRP Config, it is used to configure each port's GVRP ope-
ration mode, in which there are seven parameters needed to be configured
described below.
Parameter Description:
GVRP State Setting: This function is simply to let you enable or disable
GVRP function. You can pull down the list and click the <Downward>
arrow key to choose "Enable" or "Disable". Then, click the <Apply>
button, the system will take effect immediately.
Join Time:
Used to declare the Join Time in unit of centisecond. Valid time range:
20 –100 centisecond, Default: 20 centisecond.
Leave Time:
Used to declare the Leave Time in unit of centisecond. Valid time
range: 60 –300 centisecond, Default: 60 centisecond.
Leave All Time: A time period for announcement that all registered
device is going to be de-registered. If someone still issues a new join,
then a registration will be kept in the switch. Valid range: 1000-5000
unit time, Default: 1000 unit time.
Default Applicant Mode: The mode here means the type of partici-
pant. There are two modes, normal participant and non-participant,
provided for the user's choice.
Normal: It is Normal Participant. In this mode, the switch participates
normally in GARP protocol exchanges. The default setting is Normal.
Non-Participant: It is Non-Participant. In this mode, the switch does
not send or reply any GARP messages. It just listens messages and
reacts for the received GVRP BPDU.
Default Registrar Mode: The mode here means the type of Registrar.
There are three types of parameters for registrar administrative control
LANCOM ES-2126+ and LANCOM ES-2126P+
Chapter 4: Operation of Web- based Management
83
Advertisement
Table of Contents
