Ping; Watchdog - Lancom ES-2126+ Manual

Hide thumbs Also See for ES-2126+:
Table of Contents

Advertisement

LANCOM ES-2126+ and LANCOM ES-2126P+
Chapter 4: Operation of Web- based Management
4.19.3

Ping

Ping Test function is a tool for detecting if the target device is alive or not
through ICMP protocol which abounds with report messages. The switch pro-
vides Ping Test function to let you know that if the target device is available
or not. You can simply fill in a known IP address and then click <Ping> button.
After a few seconds later, the switch will report you the pinged device is alive
or dead in the field of Ping Result.
4.19.4

Watchdog

Watchdog function is a tool for detecting if the target device is alive or not
through supports to ping one host IP address. It can be configured via web UI,
CLI and SNMP. It supports continuing ping failed times counter setting.
130
Parameter Description:
IP Address: An IP address with the version of v4, e.g. 192.168.1.1.
Default Gateway: IP address of the default gateway.
For more details, please see the section of IP address in Chapter 2.
If only one time Ping successful, then all Ping Failed Counter will reset
to zero and re-account.
Parameter
State:
To enable or disable the watchdog function. Default is disable
Time Gap:
To support the time gap for ping test.
Host
To support to ping one host IP address. You need to configure one
host IP address which you want to ping it.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Es-2126p+

Table of Contents