Table of Contents
Advertisement
LANCOM GS-2124
Chapter 3: Configuring and monitoring the LANCOM Switch
3.1.2
Starting the Command Line Interface over the network
If you know the device's IP address (see section above) and the LANCOM
Switch is accessible from your computer via the network, the you can use the
command line interface via the network.
³
·
3.1.3
Starting the Command Line Interface over the serial connection
If you do not know the IP address of the device, you can use the command
line interface via a serial connection.
³
·
20
To do this, start a console such as Telnet and enter the device's IP address
as the target.
Log on with user name and password (default: admin, admin).
Use the serial configuration cable to connect the LANCOM Switch to the
configuration computer
Switch').
Start a terminal program on the configuration computer, such as Hyper-
terminal under Windows. Use the following parameters for the connec-
tion:
Baud rate: 115200
Stop bits: 1
Data bits: 8
Parity: N
Flow control: None
(→
"Mounting and connecting up the LANCOM
Advertisement
Table of Contents
