Load Match Elf - HP 8753E User Manual

MATCH
The measured value, SLIM, consists of signal components that vary as a function of
relationship between Esr and &A as well as E LF and f&2& so the input and output reflection
coefficients of the test device must be measured and stored for use in the &IA error-correction
computation. Thus, the test setup is calibrated as described above for reflection to establish
the directivity, Enr , source match, Esr , and reflection frequency response, Em, terms for
reflection measurements on both ports.
Now that a calibrated port is available for reflection measurements, the thru is connected and
load match, ELF, is determined by measuring the reflection coefficient of the thru connection.
Transmission signal path frequency response is then measured with the thru COMected. The
data is corrected for source and load match effects, then stored as transmission frequency
response, Err.
Note
It is very important that the exact electrical length of the thru be known.
Most calibration kits assume a zero length thru. For some connection types
such as Type-N, this implies one male and one female port. If the test system
requires a non-zero length thru, for example, one with two male test ports, the
exact electrical delay of the thru adapter must be used to modify the built-in
calibration kit definition of the thru.
Isolation, EXF, represents the part of the incident signal that appears at the receiver without
set in the transmission configuration and with terminations installed at the points where the
test device will be connected. Since isolation can be lower than the noise floor, it is best to
increase averaging by at least a factor of four during the isolation portion of the calibration.
___ ; , . . _* . , . , : , : ~ : . : . , . : . : . : . : . : . : . : . : : . : . : . , . : . : . : . : . , . : . . . : . : . : . : . : . : . : . : ~ . : . : . : . : . : . : : : : : : : : : . : : : : : : : : : : : : : : : : : : : : : . , : f : : ; : . . : . : . : : : : . : . . . : . . . . : . ;
resume after a change to the averaging factor.
If the leakage fails below the noise floor, it is best to increase averaging before calibration.
In this case, ommitting isolation is better than measuring the isolation standards without
increasing the averaging factor.
6-66 Application and Operation Concepts
PORT
PORT
Figure 6-44. Load Match Em
MATCH
the