Deleting Frequency Segments - HP 8753E User Manual

Deleting Frequency Segments

that you want to delete).
keys to locate and position the segment next to the pointer (>), shown on the display. Or
press ~~~~~~~: and enter the segment number followed by (XJ
The analyzer deletes the segment and moves the remainder of the segments up one number.
Compensating for Directional Coupler Response
If you use a directional coupler to sample power in your measurement conhguration, you
should enter the coupled arm power loss value into the power loss table, using the following
procedure. You can enter the loss information in a single segment, and the analyzer will assume
that the value applies to the entire frequency range of the instrument. Or, you can input actual
measured power loss values at several frequencies using up to 55 segments, enhancing power
accuracy.
The analyzer shows the notation EMPTY, if you have not entered any segment information.
factor data point, followed by the appropriate key: @J Irln_u Lk/m.
. . . . . . . . . i . . < a: .. . . .
coupler (or power splitter) at the frequency that you have entered in the previous step.
Complete the power loss entry by pressing (XJ @@.
Note
Remember to subtract the through arm loss from the coupler arm loss before
entering it into the power loss table, to ensure the correct power at the output
of the coupler.
4. Repeat the previous two steps to enter up to 55 frequency segments, depending on the
required accuracy.
You may enter multiple segments in any order because the analyzer automaticalIy sorts them
and lists them on the display in increasing order of frequency.
If you only enter one frequency segment, the analyzer assumes that the single value is valid
over the entire frequency range of the correction.
5-36 Optimizing Measurement Results
. . . s i . i i /. . . . . . . % A , . , , . . . . . : , . . . . . . . . . . . . . _ . . . . . . . . . . . . . . . . . . . : : . . . : : . . . : . . ; ; . : ; . . , , . . . . . , . , , , . . , , , ,
,