Connections For A One-Sweep Power Meter Calibration For Mixer Measurements - HP 8753E User Manual

11. lb perform a one sweep power meter calibration over the IF frequency range at 0 dBm,
press:
Note Because power meter calibration requires a longer sweep time,...yyou may want
to reduce the number of points before pressing ~~~;~~~~. After the
power meter calibration is finished, return the number of points to its originaI
12.
Once completed, the display should read 0 dBm.
Make the connections as shown in Figure 3-6 for the one-sweep power meter calibration
13.
over the RF range.
POWER METER

Connections for a One-Sweep Power Meter Calibration for Mixer Measurements

14. To set the frequency offset mode Lo frequency from the analyzer, press:
NETWORK ANALYZER
I --Ic
Figure 3-6.
.
Making Mixer Measurements 34