If You Are Plotting To A Pen Plotter - HP 8753E User Manual

If Yim Are Plotting to a Pen Plotter
2. Configure the analyzer for one of the following plotter interfaces:
Choose ~~~~~~~~~~~~~~. if your plotter has an HP-IB interface, and then conllgure the
n
plot function as follows:
a. Enter the HP-IB address of the plotter (default is 05), followed by (ZJ
the plot function as follows:
until the correct function appears.
device use (printers or plotters).
I/O, and cannot be used for printing or plotting.
function as follows:
b. To select the transmission control method that is compatible with your plotter, press
appears.
q If you choose ~~~~~~~~I the handsh*e method sows the pIotter to controI the
data exchange by transmitting control characters to the network analyzer.
If you choose .~~~~~~~, the handshake method allows the plotter to control the data
q
exchange by setting the electrical voltage on one line of the RS-232 serial cable.
Note
Because the +@Q&IX@ handshake takes place in the hardware rather than the
Printing, Plotting, and Saving Measurement Results
. . . . . . /.li
method