Sequencing Special Functions Menu - HP 8753E User Manual

between the following output parameters of the 'ITL output signal:
The TTL output signals are sent to the sequencing BNC rear panel output.

Sequencing Special Functions Menu

Sequence Decision Making Menu
Functions menu.
Decision making functions are explained in more detail below. These functions check a
condition and jump to a specified sequence if the condition is true. The sequence called must
be in memory. A sequence call is a one-way jump. A sequence can jump to itself, or to any of
the other five sequences currently in memory. Use of these features is explained under the
specific softkey descriptions
Decision Making Functions
Decision makiug fimctions jump to a softkey location, not to a specmc sequence
Limit test, loop counter, and do sequence commands jump to any sequence residing in the
specilled sequence position (1 through 6). These commands do not jump to a specific sequence
title. Whatever sequence is in the selected softkey position, will run when these commands are
executed.
Having a sequence jump to itself
A decision making command can jump to the sequence it is in. When this occurs, the sequence
starts over and all commands in the sequence are repeated. This is used a great deal in
conjunction with loop counter commands. See the loop counter description below.
decision making function. Refer to "The GPIO Mode" earlier in this section.
Limit test decision making
A sequence can jump to another sequence or start over depending
commands require you to enter the destination sequence.
the result of a lhnit
on