Adapter Kits - HP 8753E User Manual

Accurate operation of the analyzer system can be verified by measuring known devices other
than the standards used in calibration, and comparing the results with recorded data.
HP 86029B 7-mm Verifkation Kit
This kit contains traceable precision 7-mm devices used to confIrm the system's error-corrected
measurement uncertainty performance. Also included is verification data on a 3.5 inch disk,
together with a hard-copy listing. A system verification procedure is provided with this kit and
The foIIowing RF cables are used to connect a two-port device between the test ports. These
cables provide shielding for high dynamic range measurements.
HP 11867D 7-mm l&t Port Return Cable Set
This set consists of a pair of test port return cables that can be used in measurements of 7-mm
devices. They can also be used with connectors other than 7 mm by using the appropriate
precision adapters.
HP 11867B 75 Ohm Type-N Test Port Return Cable Set
This set consists of test port return cables for use with the HP 8753E Option 075.

Adapter Kits

HP 11862B 50 to 75 Ohm Minimum Loss Pad.
This device converts impedance from 50 ohms to 75 ohms or from 75 ohms to 50 ohms It is
used to provide a low SWR impedance match between a 75 ohm device under test and the
HP 8753E network analyzer (without Option 075).
These adapter kits contain the connection hardware required for making measurements on
devices of the indicated connector type.
HP 11853A 50 Ohm Type-N Adapter Kit
n
HP 11854A 50 Ohm BNC Adapter Kit
n
HP 11855A 75 Ohm Type-N Adapter Kit
n
1 l-2 Compatible Peripherals