HP 8753E User Manual page 597

Information When list IF bandwidth has been enabled and swept list mode is on, you will
Message
not be able to change the IF bandwidth using the &E?#& key. To change the IF
bandwidth, edit the swept list table.
Error Number The disk unit or volume number set in the analyzer is not valid. Refer to the
46 disk drive operating manual.
Information Continuing with the initialize operation will destro@ any data currently on the
disk.
Message
Error Number The disk initialization failed, probably because the disk is damaged.
4 7
Error Number All instrument state registers have been cleared from memory along with any
5 6
saved calibration data, memory traces, and calibration kit definitions.
Additionally, all user-settable selections (such as HP-IB addresses) are set to
their defaults.
Error Number Your last front panel or HP-IB request could not be implemented due to
51 insufficient memory space. In some cases, this is a fatal error from which you
can escape only by presetting the instrument.
Error Number There is not enough memory available for the print or plot function. Increase
168 the available memory by changing or eliminating a memory-intensive operation
such as reducing the number of points in the sweep.
Error Mesqes lo-13