HP 8753E User Manual page 275

The analyzer sweep time does not change proportionally with the number of points, but as
indicated below.
Different sweep speeds are associated with the following three types of non-power sweeps.
Choose the sweep type that is most appropriate for your application.
Select the sweep type:
2.
. . . . . . . . . . . . . . . .
q
points are of interest.
q sled :~~~~~ for the &test sweep when the frequency pohb of inter& we h tl.,e
lower part of the frequency span selected.
Viewing a single channel will increase the measurement speed if the analyzer's channels are in
alternate, or uncoupled mode.
2. Press @iKi) and &HAN] to alternately view the two measurement channels
If you must view both measurement channels simultaneously (with dual channel), use the
chop sweep mode, explained next.
201 0.106
401 0.181
801 0.330
1601 0.633
1 Preset condition, CF- lGHz,
Span= lOOMHz, Correction
Measurement speed can be
improved by selecting the
widest IF BW setting of
points.
Optimizing Measurement Results 5-53