HP 8753E User Manual page 629

2. Configure the analyzer for one of the following plotter interfaces:
. Choose :,~~~.~~~~~~~~ if your plotter has ~ HP-IB hterface, and then condgure the
plot function as follows:
a. Enter the HP-IB address of the printer (default is 05), followed by (XJ).
the HP-IB bus.
c. Press LLocal) and ~~~~~~~:~~~~~~~ if there is an external controller connected to the
HP-IB bus.
the print function as follows:
q
until the correct function appears:
, If you choose .~~~~~~~~ the parallel port is dedicated for normal copy
. . . . .
device use (printers or plotters).
n If you choose ~~~~~~~~~~:, the pa&al pod is de&ated for general purpose
I/O, and cannot be used for printing or plotting.
Choose SRI@&% if your printer has a serial (RS-232) interface, and then configure the print
n
function as follows:
. . . . . . . . . . . . . . . . . . . . . . . . , . : . . . . . y ( , . , , , , ~ , , , ~ ~ , , : . , , , : , , : , , : : , , , . ; . : . : . : . : . : . : . : _ : , . : . : . : . ~ . : . : . > : : . . . . . : . : . : . : . : . : . : . : . ~ : . : . : . : . : . : . : . : . : . : . : . : ~ ~ ~
b. lb select the transmission control method that is compatible with your printer, press
appears:
data exchange by transmitting control characters to the network analyzer.
exchange by setting the electrical voltage on one line of the RS-232 serial cable.
. . _ _
. . . . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . A : " , " ; ; ; ; ; , . , . , . , . . . , . , . , . ~ . ~ . . . . . . . . . . . . ; ; ~ , . . . . . . . . v i: '