Operating Conditions - Carl Valentin Dynacode IP Series Operating Manual

Dynacode IP Series
Conditions for
installation place
Installation of
power supply
08.16
5

Operating Conditions

Before initial operation and during operation these operating
conditions have to be observed to guarantee save and interference-
free service of our direct print modules.
Therefore please carefully read these operating conditions.
Shipment and storage of our direct print modules are only allowed in
original packing.
Installation and initial operation of direct print modules is only allowed
if operating conditions were fulfilled.
Commissioning is prohibited until it can be established that, where
relevant, the machine into which the partly completed machinery is to
be incorporated complies with the provisions of Machinery Directive
2006/42/EC.
Initial operation, programming, operation, cleaning and service of our
direct print modules are only recommended after careful study of our
manuals.
Operation of direct print modules is only allowed by especially trained
persons.
NOTICE!
Perform trainings regularly. Content of the training are chapter 5
(Operating Conditions), chapter 9 (Loading the Transfer Ribbon
Cassette) and chapter 14 (Maintenance and Cleaning).
These indications are also valid for someone else's equipment
supplied by us.
Only use original spare and exchange parts.
Please contact the manufacturer with respect to spare/wear parts.
The installation place of direct print module should be even, free of
vibration and currents of air are to be avoided.
The direct print modules have to be installed to ensure optimal
operation and servicing.
The installation of the power supply to connect our direct print
modules has to be effected according to the international rules and
regulations, especially the recommendations of one of the three
following commissions:

International Electronic Commission (IEC)

European Committee for Electro technical Standardisation
(CENELEC)

Verband Deutscher Elektrotechniker (VDE)
Our direct print modules are constructed according to VDE and have
to be connected to a grounded conductor. The power supply has to be
equipped with a grounded conductor to eliminate internal interfering
voltage.
Operating Manual
Operating Conditions
15