Ribbon Save / Foil Saving - Carl Valentin Dynacode IP Series Operating Manual

Dynacode IP Series
Performance
information
Expert parameters
Printhead down time
Ribbon motor early
start time
Minimal print speed
Print offset border
calculation
08.16
Press key to arrive the next menu item.
sa/mm: The smallest possible distance of two prints with full ribbon
save (the print offset must be set to the minimum value). As basis for
the calculation the set ribbon save parameters are used, as well as
mode and especially the indicated max. print speed.
cmin: Max. number of cycles per minute.
so/mm: Indicates the loss of ribbon save, i.e. how many mm transfer
ribbon is effectively lost.
Press key to arrive the next menu item.
This menu item is password protected. Enter password, press key
to confirm the input and the following parameters are
indicated:
PhDownT = printhead down time in ms:
This is used from ribbon save algorithm for the calculation of start time
of printhead upwards movement.
REStartT = ribbon motor early start time in ms:
This value is added to the increase time of transfer ribbon movement.
Time indication for the time between 'motor reached material speed'
and 'printhead burns'.
If the same value is entered as for PhDownT, the printhead upwards
movement is not started before the transfer ribbon motor reached the
material speed.
Press key to arrive the next menu item.
MinSpeed = minimal print speed:
If the min. print speed is increased, the max. number of cycles is also
increased.
Calcoff = Turn On/Off print offset border calculation:
If this parameter is set to Off, then a smaller offset as the required
print offset can be entered.
Operating Manual

Ribbon Save / Foil Saving

117