Chassis Installation; Rear Panel Connectors; Lcd Panel Connection; Ethernet Connection - IEI Technology WSB-9152 User Manual

WSB-9152 CPU Card
FSB Speed
Before the WSB-9152 CPU card is installed into a chassis, make sure the jumper settings
are properly configured. For more information about jumper settings and configurations,
please refer to Section 3.4: Onboard Jumpers above.
4.5

Chassis Installation

After the CPU, the cooling kit, and the DIMM modules have been installed and after the
internal peripheral connectors have been connected to the peripheral devices and the
jumpers have been configure, the CPU Card can be mounted into a chassis.
To mount the CPU Card into a chassis please refer to the chassis user guide that came
with the product.
4.6

Rear Panel Connectors

4.6.1 LCD Panel Connection

The conventional CRT monitor connector, VGA1, is a 15-pin, female D-SUB connector.
Pin assignments can be seen in that can be connected to external monitors.

4.6.2 Ethernet Connection

The rear panel RJ-45 connectors can be connected to an external LAN and communicate
with data transfer rates up to 1Gb/s.

4.6.3 USB Connection

The rear panel USB connector provides easier and quicker access to external USB
devices. The rear panel USB connector is a standard connector and can easily be
connected to other USB devices.
84
1-84
®
IEI Technology, Corp.