Lvds Panel Voltage Jumper; Reset Cmos Jumper; Table 3-27: Jp1 Jumper Settings - IEI Technology WSB-9152 User Manual

WSB-9152 CPU Card

3.4.1 LVDS Panel Voltage Jumper

Jumper Label:
Jumper Type:
Jumper Settings:
Jumper Location:
This jumper sets the voltage for the LVDS panel at 3.3V. The settings are shown in Table
3-27.
WARNING:
Selecting the wrong voltage will burn
documents provided by the vendor for the correct voltage.
JP1 LVDS Voltage Select
1-2 closed 3.3V (default)

Table 3-27: JP1 Jumper Settings

3.4.2 Reset CMOS Jumper

Jumper Label:
Jumper Type:
Jumper Settings:
Jumper Location:
If the CPU Card fails to boot due to improper BIOS settings, use this jumper to clear the
CMOS data and reset the system BIOS information. To do this, use the jumper cap to
close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1 and 2.
70
1-70
JP1
2 pin header
See Table 3-27
See Figure 3-23
the LCD. Please check LCD technical
JP2
3 pin header
See Table 3-28
See Figure 3-23
®
IEI Technology, Corp.