Figure 4-4: Securing The Cooling Kit - IEI Technology WSB-9152 User Manual

WSB-9152 CPU Card
NOTE:
The CF-518-RS heatsink comes with a sprayed layer of thermal paste.
Make sure you do not accidentally wipe away the thermal paste while
unpacking or installing the heatsink. Thermal paste between the CPU and
the heatsink is important for optimum heat dissipation.
To install the CF-518 cooling kit, please follow the steps below.
Step 1: Place the cooling kit onto the CPU. Make sure that the CPU cable can be
properly routed when the cooling kit is installed.
Step 2: Properly align the cooling kit. Make sure its four threaded screw fasteners can
pass through the pre-drilled holes on PCB.
Step 3: Secure the cooling kit. From the solder side of the PCB, align the provided nut
caps to the heatsink screw threads that protrude through the PCB holes. Without
over tightening the nut caps, insert them onto the protruding screw threads to
secure the cooling kit to the PCB board. (See Figure 4-4)

Figure 4-4: Securing the Cooling Kit

Step 4: Connect the fan cable. Connect the cooling kit fan cable to the FAN2 connector
80
1-80
®
IEI Technology, Corp.