Dimm Module Installation; Peripheral Device Connection; Ide Disk Drive Connector (Ide1); Table 4-1: Iei Provided Cables - IEI Technology WSB-9152 User Manual

WSB-9152 CPU Card

4.3.3.2 DIMM Module Installation

The WSB-9152 CPU card has two DDR SDRAM DIMM sockets. To install the DIMM
modules, follow the instructions below.
Step 1: Pull the two white handles on either side of the DIMM socket down.
Step 2: Align the DIMM module with the DIMM socket making sure the matching pins
are correctly aligned.
Step 3: Insert the DIMM module slowly. Once you are sure it is correctly inserted, push
down firmly. The white handles on either side of the socket will move back up
and lock the module into the socket.

4.3.4 Peripheral Device Connection

Cables provided by IEI that connect peripheral devices to the CPU Card are listed in
Table 4-1. Cables not included in the kit must be separately purchased.
Quantity Type
1 ATA 66/100 flat cable
2/4 SATA cables (SATA-II channel models have 4)
1/2 SATA power cable (SATA-II channel models have 2)
1 Keyboard/ PS2 mouse Y cable
1 ATX-12V cable
1 RS-232 cable
1 USB cable
1 LPT cable (optional)
1 FDD cable (optional)
1 DVI cable (optional)

Table 4-1: IEI Provided Cables

4.3.4.1 IDE Disk Drive Connector (IDE1)

The cable used to connect the CPU card to the IDE HDD is a standard 44-pin ATA 66/100
flat cable. To connect an IDE HDD to the CPU Card, follow the instructions below.
82
1-82
Step 0:
®
IEI Technology, Corp.