Fsb Selection Jumper; Table 3-28: Jp2 Jumper Settings; Table 3-29: Jp3 Jumper Settings - IEI Technology WSB-9152 User Manual

If the "CMOS Settings Wrong" message displays during the boot up process, you may
then try to correct the fault by pressing the F1 to enter the CMOS Setup menu. You may
then do one of the following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After you have done one of the above, save your changes and exit the CMOS Setup
menu.
JP2 CLEAR CMOS
1-2 closed Normal (default)
2-3 closed Clear CMOS

Table 3-28: JP2 Jumper Settings

3.4.3 FSB Selection Jumper

Jumper Label:
Jumper Type:
Jumper Settings:
Jumper Location:
This jumper allows the user to set the FSB speed. Refer to the CPU technical documents
that came with the CPU you wish to install on the WSB-9152. After determining the FSB of
the CPU, change the jumper settings in accordance with the settings shown in Table 3-29.
JP3 CPU FSB Select
1-2 closed 400MHz
2-3 closed 533MHz (default)

Table 3-29: JP3 Jumper Settings

JP3
3 pin header
See Table 3-29
See Figure 3-23
WSB-9152 CPU Card
1-71 71