Samlexpower Evolution EVO-2212 Owner's Manual page 99

SECtION 3 |
3.2 PoWeR on / PoWeR oFF
Power on
To power ON the unit, press and hold the on/oFF Key until competion of sequence
expained below:
POWER ON...
ò
SEARCHING ID...
ID= 1
ò
EVO-XXXX
INVERTER/CHARGER
Power oFF
Press on/oFF Key and hold for 5 seconds to turn OFF the EVO Inverter Charger.
POWER OFF...
3.3 DAte AnD tiMe SetUP
Set date and time as per procedure given at Section 4.9: "GROUP 6 PARAMETER SETUP: TIME
SETTING".
3.4 StAnDBY MoDe
This Mode is required to be switched ON manually during firmware uploading procedure for
EVO Inverter Charger. Firmware upload is carried out through the SD Card slot [9, Fig 1.1(a)].
When firmware uploading procedure is initiated, the user will be prompted to switch ON
Standby Mode – message on the LCD screen will show "Press power key to stop inverter".
Once firmware upload is completed, the EVO exits the Standby Mode automatically.
note: When in Standby Mode, the EVO will stop inverting or charging / passing through.
Standby Mode may also be used to temporary halt normal operation of the Inverter Charger
without switching OFF the unit completely.
Operation
When the EVO Inverter Charger is OFF and the on/oFF key is
pressed and held, the LCD screen shows "POWER ON..." and
the Status LED flashes 3 times. EVO-RC starts to search for the
communication ID of the EVO Inverter Charger it is attached to.
The LCD screen shows "SEARCHING ID" on the first line and
shows the ID number found on the second line. the on/oFF
Key may be released now (At this point, around 2 sec would
have elapsed from the time the ON/OFF Key is kept pressed
VX.XX
continuously). When the default ID of "1" is found, the display
will then show the EVO Inverter Charger Model No. (4Xs to
show 2212, 2224, 3012 or 4024) and Firmware Version (3 digit
number X.XX) as shown on the left.
When EVO Inverter Charger is ON and the on/oFF key is
pressed and held for minimum of 5 seconds, the LCD screen
will show "POWER OFF..." and both the Status and Alarm
LEDs will turn ON. Now release the ON/OFF key (Please note
that Power Off sequence will be completed and display
"POWER OFF..." will disappear only when the ON/OFF key
is released).
note: if the eVo inverter charger has Ac input voltage
over 60VAc, the Power oFF function is disabled and the
unit will remain in the on condition if the power off
sequence is attempted. the Ac input must be removed
before the unit can be powered oFF.
APPENDIX A
SAMLEX AMERICA INC. | 7