Samlexpower Evolution EVO-2212 Owner's Manual page 107

SECtION 4 |
4.2 PARAMeteR SetUP PRoceDURe – GeneRAL
Please refer to Fig 4.3 below.
The enter key is used to enter Parameter Setup Mode from any Operating Mode Screen in Fig 3.2.
Example in Fig 4.3 below starts with Inverting Mode Screen (Group 2, Page 1 in Fig 3.2). After the
enter key is pressed, the Up/Down keys are used to navigate to the different Parameter Groups
(Groups 1 to 7). When the Group for the desired setting is displayed on the LCD, the enter Key
is used again to select this Group. The Up and Down Keys are used to move to the individual
parameters within the Group.
Pressing the Back Key will exit the specific Parameter, or Group backing to previous level.
There is a 30 second timeout for setting parameters; after 30 seconds the Setting Mode will
be cancelled and the EVO-RC will revert to the mode associated with current operation.
It is highly recommended to set the EVO Date and Time (Parameter Group 6) as this value is
used to record data logging files. (Refer to Section 4.9 for Date and Time set up).
Enter Key
Back Key
Any Operationg Mode
Screen from Fig 3.2
INVERTING
OUTPUT
Fig 4.3 "Select Group" Menu Map and example for Setting Bulk current
noteS:
* Group Up is shown with downward pointer  because Group Nos. in this Menu Map
increase in the downward direction
** Group Down is shown with upward pointer  because Group Nos. in this Menu Map
decrease in the upward direction
*** Group 7 screen will be shown only when SD card is inserted.
Parameter Setup
ò
Group up (Up Key)*
Group down (Down Key)**
Group 1
120.00V
Group 2
Group 3
Group 4
Group 5
Group 6
Group 7
"Select Group" Menu Map
SELECT GROUP
CHARGE CURVE
ò
SELECT GROUP
INPUT SETTING
ò
SELECT GROUP
INPUT LOW LIMIT
ò
SELECT GROUP
INPUT HIGH LIMIT
ò
SELECT GROUP
OTHER FUNCTION
ò
SELECT GROUP
TIME SETTING
ò
***
SELECT GROUP
STOP SD CARD
APPENDIX A
Parameter Setup Screen
(eg. BULK CURRENT)
BULK CURRENT
40 A
SAMLEX AMERICA INC. | 15