Samlexpower Evolution EVO-2212 Owner's Manual page 83

SECTIOn 6 |
Status
Seen during Power-On
Sequence
Indicates completion of
Power-On Sequence after
Power ON/Off button is
pressed for 2 sec
Seen during Power-Off
Sequence
Indicates completion of
Power-Off Sequence after
Power ON/Off button is
pressed for 5 sec
Normal charging
Equalization charging
Inverting (Discharging)
Low battery alarm
Power saving
Standby
fault
6.4 oPtionAl remote control evo-rc (see Appendix A) for
ProgrAmming of moDeS of oPerAtion AnD PArAmeterS
Optional remote Control Model EVO-rC (fig 2.4) will be required for more advanced control
and monitoring. Please see separate Owner's Manual for EVO-rC at Appendix A. The remote
Control comes with 10M / 33 ft., rJ-45 Data Cable. The remote plugs into rJ-45 Jack on
the front panel of the unit (7, fig 2.1). It has provision for Data Logging using SD Card of up
to 16 Gb (fAT16 / fAT32). It also has its own real Time Clock and Super Capacitor Type of
battery.
Detailed messaging is available through its LCD display and LEDs. This remote will also
be required for programming of various parameters to suit specific requirements. Each
programmable parameter has a Default Value. This unit has been shipped with the various
parameters set at the Default Values. Programmable and Default values are shown in Tables
6.2 to 6.6:
Operation, Protections and Troubleshooting
tAble 6.1 leD AnD buZZer inDicAtionS
green leD
marked "on"
(12, fig 2.1)
flash 3 times
On
flash 1 time per sec
flash 2 times per
sec
On
On
flash 1 time per
3 sec
Off
Off
red leD
marked
"fault" (13, fig
2.1)
Off
On
Off
Off
Off
flash 1 per sec
Off
Off
On
SAMLEX AMErICA INC. | 83
buzzer
Off
Off
Off
Off
beep per 3 second
(Default Off)
beep per 1 second
Off
Off
On