Section 4 - Samlexpower Evolution EVO-2212 Owner's Manual

SECTIOn 3 |
3.15 Shore bASeD inStAllAtion
3.15.1 typical Shore based installation
fig. 3.13 illustrates a typical shore based installation
battery is connected to the DC input connections through DC Electrical Panel with an ap-
—
propriate fuse to protect the DC input cables against short circuit
battery Temperature Sensor Model EVO-bCTS is installed on the Positive or Negative post
—
of the battery and connected to the port for the Temperature Sensor
Supplementary battery charging is being carried out through a solar array and a Charge
—
Controller connected to the DC input provided for external battery charger
AC input to the EVO is fed from the Grid and Generator Panel
—
AC output from the EVO is fed to the AC Electrical Sub-Panel for EVO
—
Automatic Generator start/stop is possible. Please see Section 4.7 for details
—
!
cAution!
—
When using generator, please ensure the following:
• Neutral of the generator is bonded to the chassis of the generator and the chassis is
bonded to the Earth Ground (Ground rod "GE").
• If the Generator is a 120VAC / 240VAC Split Single Phase with 120 VAC phase fed to
the EVO, then both 120VAC Split Phases of the generator should be equally loaded
(balanced) to prevent deterioration of regulation of generator's output voltage. Poor
regulation of generator output voltage may lead to interruption of charging in the EVO.
!
Attention!
Lorsque vous utilisez le générateur, vérifiez les points suivants :
• Neutre du générateur est collée sur le châssis de l'alternateur et le châssis est collé à la terre (masse tige "GE").
• Si le générateur est a 120VCA / 240VCA Phase unique fendue avec phase 120VCA nourri à l'EVO, puis les deux
120VCA Split Phases du générateur devrait être également chargé (équilibré) pour prévenir la détérioration du
règlement de tension de sortie du générateur. Une mauvaise régulation de tension de sortie du générateur peut
entraîner l'interruption de la charge à l'EVO.
56 | SAMLEX AMErICA INC.
Installation