Components & Layout - Samlexpower Evolution EVO-2212 Owner's Manual

SECTIOn 2 |
2.
1 mAin unit: lAyout-front (fig 2.1)
10A
10B
10C
5
1. battery Positive (+) Input Connector – M10 x 1.25 Nut & bolt (rED Protection Cover 1(a) is removed)
1a. rED Protection Cover for battery Positive (+) Input Connector
2. battery Negative (-) Input Connector – M10 x 1.25 Nut & bolt (black Protection Cover 1(b) is removed)
2a. black Protection Cover for battery Negative (-) Input Connector
3. External Charger (+) Input Connector – M12 x 0.75 Thumb Nut and bolt
4. External Charger (-) Input Connector - M12 x 0.75 Thumb Nut and bolt
5. DC Side Grounding Connector – hole Dia 6.5mm for wire sizes up to 25mm
M-8. This is internally connected to the metal chassis of the unit.
6. rJ-45 Jack for Temperature Sensor "EVO-bCTS" (fig. 2.5)
7. rJ-45 Jack for EVO-rC remote
8. Air inlet vents for 2 internal cooling fans [Additional air inlet vents at the bottom (not shown)]
9A, 9b. rJ-45 Jacks for Communication Ports "COMM 1" and "COMM 2" - for rS-485 networking and
MODbuS Serial Communication Protocol (for future use)
9c, 9D. rJ-45 Jacks for Communication Ports "COM 3" and "COM 4" - for "CANbus" Serial
Communication Protocol (for future use)
10A to 10c. Knock outs for AC wiring inlet/exit wiring entry (Diameter: 27.8mm / 1 3/32") (for ¾" conduit/fittings)
11. ON/Off Push button
12. Green LED "ON"
13. red LED "fault"
14. Output Terminals for Status relay - Screw M 2.5; Wire size: up to 4mm
• NO (Normally Open)
• Common
• NC (Normally Closed)
15. +12V Input Terminals for "remote On Off" (9 to 15V, 3mA) - Screw M 2.5; AWG #30 to #12
16. Output Terminals for +12VDC source (up to 100mA) (available only when the unit is ON) - Screw
M 2.5; Wire size: up to 4mm
Components & Layout
12 13
11
14
15
16
9A
9B
9C 9D
6 7
fig 2.1 layout-front
(i) When the relay is Off, "NO" and "Common" contacts are open and
"NC" and "Common" contacts are closed.
(ii) When the relay is ON, "NO" and "Common" contacts are closed and
"NC" and "Common" contacts are open.
/ AWG#12
2
1
8
3 4
2
1a Red
Protection Covers for Battery Terminals
(AWG #4). Set Screw
2
/ AWG #12
2
SAMLEX AMErICA INC. | 25
1b Black