Installation; Mounting The Panel; Terminal Board - Bentel Security Omnia 8/L Manual

Mounting the Panel

Step 1
Step 2
Step 3
Step 4

Terminal board

Ø
Ø
6
The Panel should be located in a dry area, preferably near the power
source and incoming telephone line.
Follow the installation instructions carefully, and refer to figure 1.
Unfasten the screws (1) and remove the front.
Check for cable conduits and water pipes before drilling. Use the back box
as a drill pattern.
Attach the NCDUEVOX voice board (if used).
Pull the wires through the hole (10) and mount the back box.
Below is a description of the Panel terminal board, keypads and key read-
ers.
The Terminal column shows the terminal number and terminal identifier (in
square brackets).
The DESCRIPTION column provides a description of each terminal.
The V column shows the voltage on the corresponding terminal.
The I column shows the maximum current for each terminal.
Where (1) or (2) is shown as the value in the I column----refer to the foot-
note below the table.

INSTALLATION

Security System Control panel Omnia 8/L