Toc Calibration Setup - Hach ANATEL PAT700 Operator's Manual

Page 78
The recommended correlation coefficient, a user-accepted value (R
The calibration will be accepted if the R
change is within the specified ±15% limit.

TOC calibration setup

Use default settings and use custom settings radio buttons
settings or custom settings. The default selection is use default settings.
Back icon
calibration are retained.
Forward icon
• If you select default settings, the load bottles dialog box opens. See
• If you select custom settings, the custom setup dialog box opens. See
• All changes made to the TOC calibration are retained.
Cancel icon
dialog boxes are lost.
Operator Manual
Figure 6-3 TOC calibration setup dialog box
takes you back to the previous dialog box. All changes made to the TOC
takes you to the next dialog box.
you select custom settings and then touch the back button, the analyzer uses the
default settings.
returns you to the run standards dialog box. All changes made in any of the
Bottle Mode – PAT700 Total Organic Carbon Analyzer
2
value is 0.990 or greater and the percent slope
2
), is 0.990 or greater.
enable you to select default
Figure 6-5.
Figure 6-4. If
Anatel