Printer - Hach ANATEL PAT700 Operator's Manual

Page 56
5.7

Printer

The printer icon allows you to configure the printer settings for the analyzer. You can
independently configure the printing of analysis results and the frequency of printing for online
TOC and conductivity modes.
Printer connection is made using the 9-pin D-subminiature serial port. The RS-232 interface
communicates at 9600 baud, 8 data bits, 1 stop bit, no parity.
The printout report requires a 40-column printer.
• If the printer is purchased from Hach Ultra, the switches are preset at the factory.
• If a Seiko Instruments DPU-414 Type II thermal printer is installed, the electronic DIP
Table 5-2
DIP Switch 1
Switch
1
2
3
4
5
6
7
8
DIP Switch 2
Switch
1
2
3
4
5
6
7
8
Operator Manual
switches must be set as listed in
Printer DIP switch settings
Setting
Off
On
On
Off
On
Off
On
On
Setting
On
On
On
Off
On
On
On
Off
Setup – PAT700 Total Organic Carbon Analyzer
Table 5-2:
Function
Serial input
High print speed
Auto loading enabled
Auto linefeed disabled
Enabled setting
Print density
Print density
Print density
Function
40-column printing
Backup font enabled
Normal characters
Zero = Slash
International character set = USA
International character set = USA
International character set = USA
International character set = USA
Anatel