Toc Validation Tab - Hach ANATEL PAT700 Operator's Manual

Page 68
Return to online mode checkbox
following the calibration. You may enable or disable (default) this option. When enabled, the
analyzer returns to online mode following the calibration. When disabled, the analyzer stays
at the bottle mode dialog box. All valves are closed, the pump is off, and the lamp is off.
Slope limit from previous cal text box
difference between the resulting gain factor and the current value. You may enter a value from
1 to 5%. The default value is 5%.
Slope limit from factory cal text box
difference between the resulting gain factor and the factory value. You may enter a value from
1 to 10%. The default value is 10%.
Use calibration resistor check box
the conductivity calibration process. See
Return icon
noted in the audit trail.

TOC validation tab

Return to online mode checkbox
following the validation. You may enable or disable (default) this option. When enabled, the
analyzer returns to online mode following the validation. When disabled, the analyzer stays at
the bottle mode dialog box. All valves are closed, the pump is off, and the lamp is off.
Return icon
noted in the audit trail.
Operator Manual
tells the analyzer whether or not to return to online mode
returns you to the setup dialog box and saves any changes. Any changes are
Figure 5-22 Bottle test setup dialog box, TOC validation tab
returns you to the setup dialog box and saves any changes. Any changes are
Setup – PAT700 Total Organic Carbon Analyzer
allows you to specify the acceptable percent
allows you to specify the acceptable percent
allows the use of the calibration check resistor during
Conductivity calibration, page
enables the analyzer to return to the online mode
85.
Anatel