Security - GE D30 Instruction Manual

CHAPTER 2: PRODUCT DESCRIPTION
Table 2-2: Other device functions
Function
2
Breaker arcing current (I t)
Breaker control
Broken conductor detection
Contact inputs (up to 96)
Contact outputs (up to 64)
Control pushbuttons
CyberSentry™ security
Digital counters (8)
Digital elements (48)
Direct inputs and outputs (32)
Disconnect switches
DNP 3.0 or IEC 60870-5-104 protocol
Event recorder

2.2 Security

The following security features are available:
• Password security — Basic security present by default
• EnerVista security — Role-based access to various EnerVista software screens and configuration elements. The
feature is present by default in the EnerVista software.
• CyberSentry security — Advanced security available as a software option. When purchased, the options are
automatically enabled, and the default Password security and EnerVista security are disabled.
D30 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
Figure 2-1: Single-line diagram
Function
Fault detector and fault report
Fault locator
FlexElements™ (8)
FlexLogic equations
IEC 61870-5-103 communications
IEC 61850 communications
Line pickup
Metering current, voltage, power, power
factor, frequency
Modbus communications
Modbus user map
Non-volatile latches
Non-volatile selector switch
Oscillography
Function
Setting groups (6)
Time synchronization over IRIG-B or IEEE
1588
Time synchronization over SNTP
Transducer inputs and outputs
Trip bus
User-definable displays
User-programmable LEDs
User-programmable pushbuttons
User-programmable self-tests
Virtual inputs (64)
Virtual outputs (96)
VT fuse failure
SECURITY
2
2-3