Firmware Revisions - GE D30 Instruction Manual

CHAPTER 6: ACTUAL VALUES
The order code, serial number, Ethernet MAC address, date and time of manufacture, and operating time are shown here.
The rear panel on the device contains similar information.
— UR devices with firmware 7.0x and above have three Ethernet ports that can be used on three
ETHERNET MAC ADDRESS
networks. The MAC address displays for port 1. The MAC address for port 2 is one higher. The MAC address for port 3 is one
higher than port 2. In redundant mode, the MAC addresses for ports 2 and 3 are the same as port 2.

6.5.2 Firmware revisions

ACTUAL VALUES  PRODUCT INFO  FIRMWARE REVISIONS
 FIRMWARE REVISIONS

The shown data is illustrative only. A modification file number of 0 indicates that, currently, no modifications have been
installed.
D30 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
LAST SETTING CHANGE:

1970/01/01 23:11:19
D30 Relay

REVISION: 7.3x
MODIFICATION FILE

NUMBER: 0
BOOT PROGRAM

REVISION: 7.01
FRONT PANEL PROGRAM

REVISION: 2.01
COMPILE DATE:

2013/09/15 04:55:16
BOOT DATE:

2013/09/15 16:41:32
FPGA PROGRAM:

REVISION: 01.05
FPGA DATA:

2013/09/15 16:41:32
PRODUCT INFORMATION
Range: YYYY/MM/DD HH:MM:SS
Range: 0.00 to 655.35
Revision number of the application firmware.
Range: 0 to 65535 (ID of the MOD FILE)
Value is 0 for each standard firmware release.
Range: 0.00 to 655.35
Revision number of the boot program firmware.
Range: 0.00 to 655.35
Revision number of faceplate program firmware.
Range: YYYY/MM/DD HH:MM:SS
Date and time when product firmware was built.
Range: YYYY/MM/DD HH:MM:SS
Date and time when the boot program was built.
Range: 0.00 to 655.35
Revision number for FPGA.
Range: YYYY/MM/DD HH:MM:SS
Date and time when the FPGA was built.
6
6-23