GE D30 Instruction Manual page 276
Line distance protection system
Hide thumbs
Also See for D30:
- Instruction manual (686 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (685 pages)
Table of Contents
Advertisement
FLEXLOGIC
2.
Prepare a logic diagram for the equation to produce virtual output 3, as this output is used as an operand in the virtual
output 4 equation (create the equation for every output that is used as an operand first, so that when these operands
are required they already have been evaluated and assigned to a specific virtual output). The logic for virtual output 3
is shown as follows with the final output assigned.
5
3.
Prepare a logic diagram for virtual output 4, replacing the logic ahead of virtual output 3 with a symbol identified as
virtual output 3, shown as follows.
4.
Program the FlexLogic equation for virtual output 3 by translating the logic into available FlexLogic parameters. The
equation is formed one parameter at a time until the required logic is complete. It is generally easier to start at the
output end of the equation and work back towards the input, as shown in the following steps. It is also recommended
5-144
Figure 5-65: Logic example with virtual outputs
Figure 5-66: Logic for virtual output 3
Figure 5-67: Logic for virtual output 4
D30 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 5: SETTINGS
Advertisement
Table of Contents
