GE D30 Instruction Manual page 178

PRODUCT SETUP
System functional ldName
Range: 0 to 64 VisibileString characters
Default:
This setting is similar to setting Master functional ldName, but is for the System logical device, which contains the UR
logical nodes modelling power system devices: breakers, switches, CTs, VTs, and so on, including interface to these such
as AC inputs, contact I/O, transducer I/O, and HardFiber I/O.
Prot functional ldName
Range: 0 to 64 VisibileString characters
Default:
This setting is similar to setting Master functional ldName, but is for the Prot logical device instance, which contains the
UR logical nodes modelling protection and protection related functions.
Ctrl functional ldName
Range: 0 to 64 VisibileString characters
Default:
This setting is similar to setting Master functional ldName, but is for the Ctrl logical device instance, which contains the
UR logical nodes modelling control and monitoring functions.
Meter functional ldName
Range: 0 to 64 VisibileString characters
Default:
This setting is similar to setting Master functional ldName, but is for Meter the logical device instance, which contains
the UR logical nodes modelling metering and measurement (other than PMU), including Signal Sources.
Gen functional ldName
5
Range: 0 to 64 VisibileString characters
Default:
This setting is similar to setting Master functional ldName, but is for the Gen logical device instance, which contains the
UR logical nodes modelling FlexLogic, Virtual Outputs, non-volatile latches, FlexElements, recording (for example
oscillography), security, front panel, and clock.
Location
Range: 0 to 255 ASCII characters
Default: Location
The value entered sets the value of the data attribute <LDName>/LPHD1.PhyNam.location. This data attribute is
provided by the protocol to allow the user to declare where the equipment is installed.
Latitude
Range: -90.000 to 90.000 degrees in steps of 0.001 degree
Default: 0.000 deg
The value entered sets the value of the data attribute <LDName>/LPHD1.PhyNam.latitude. This data attribute is provided
by the protocol to allow the user to declare the geographical position of the device in WGS84 coordinates -latitude.
Negative values indicate a southern latitude. WGS refers to the world geodetic system, which is used in global
positioning systems (GPS), and 84 is the current version of the standard.
Longitude
Range: -180.000 to 180.000 degrees in steps of 0.001 degree
Default: 0.000 deg
The value entered sets the value of the data attribute <LDName>/LPHD1.PhyNam.longitude. This data attribute is
provided by the protocol to allow the user to declare the geographical position of the device in WGS84 coordinates -
longitude. Negative values indicate a western longitude.
5-46 D30 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 5: SETTINGS