Pppoe Client In Diagnostic Mode Configuration Example - HP MSR Router Series Wan Access Configuration Manual

[RouterB-Dialer1] dialer timer idle 150
[RouterB-Dialer1] quit
Verifying the configuration
# Display summary information about the PPPoE session established between Router B and Router A
(PPPoE server).
[RouterB-Dialer1] display pppoe-client session summary
Bundle ID
1 1

PPPoE client in diagnostic mode configuration example

Network requirements
As shown in
in diagnostic mode, and set the diagnostic interval to 200 seconds.
Figure 20 Network diagram
Configuration procedure
1. Configure Router A as the PPPoE server:
# Configure an IP address for interface Virtual-Template 1 and specify an IP address for the peer.
<RouterA> system-view
[RouterA] interface virtual-template 1
[RouterA-Virtual-Template1] ip address 1.1.1.1 255.0.0.0
[RouterA-Virtual-Template1] remote address 1.1.1.2
[RouterA-Virtual-Template1] quit
# Enable the PPPoE server on GigabitEthernet 1/0/1, and bind the interface to Virtual-Template 1.
[RouterA] interface gigabitethernet 1/0/
[RouterA-GigabitEthernet1/0/1] pppoe-server bind virtual-template 1
[RouterA-GigabitEthernet1/0/1] quit
2. Configure Router B as the PPPoE client.
# Create dialer access group 1 and configure a dial access control rule for it.
<RouterB> system-view
[RouterB] dialer-group 1 rule ip permit
# Enable bundle DDR on interface Dialer 1.
[RouterB] interface dialer 1
[RouterB-Dialer1] dialer bundle enable
# Associate Dialer 1 with dialer access group 1.
[RouterB-Dialer1] dialer-group 1
[RouterB-Dialer1] quit
# Configure Dialer 1 to obtain an IP address through PPP negotiation.
[RouterB-Dialer1] ip address ppp-negotiate
Interface VA
GE1/0/1 VA0
Figure 20, Router A serves as a PPPoE server. Configure Router B as a PPPoE client operating
RemoteMAC LocalMAC
00e0-1400-4300 00e0-1500-4100 SESSION
65
State