Setting The Modem Answer Mode; Enabling A Modem To Obtain Caller Numbers - HP MSR Router Series Wan Access Configuration Manual

Setting the modem answer mode

To ensure correct operation of the modem, set the auto-answer mode on the user line to be the same as
the modem.
• Enable auto-answer mode if the modem is in auto-answer mode (the AA LED of the modem lights
up). This setting prevents the router from issuing a duplicate answer command after the modem
answers a call.
Disable auto-answer mode if the modem is not in auto-answer mode.
•
To set the modem answer mode:
Step
1. Enter system view.
2. Enter user line view.
3. Set the modem
answer mode.

Enabling a modem to obtain caller numbers

CAUTION:
Performing this task disconnects the modem connection.
This task is for point of sale (POS) terminal access services. It is available only on the TTY lines for AM
interfaces.
Configure this command if a bank front end processor requires the router to send the call numbers of POS
terminals for acknowledgment before it accepts data from the terminals.
For more information about POS terminal access services and caller number sending, see Terminal
Access Configuration Guide.
To enable a modem to obtain caller numbers:
Command
system-view
line { first-num1 [ last-num1 ] |
{ aux | tty } first-num2
[ last-num2 ] }
•
Enable auto-answer mode:
modem auto-answer
•
Disable auto-answer mode:
undo modem auto-answer
155
Remarks
N/A
This command is available on the following
user lines:
•
TTY lines for the following interfaces:
AM interface
Asynchronous serial interface
Asynchronous/synchronous serial
interface operating in asynchronous
mode
•
AUX line
This command is not available on the console
or VTY lines.
To display the user line for an interface, use
the display line command.
By default, auto-answer mode is disabled.