Configuring Bundle Ddr; Configuring A Dialer Interface To Place Calls - HP MSR Router Series Wan Access Configuration Manual

Step
4. (Optional.) Configure the
interface to authenticate the
caller.
To configure an interface to receive calls through a dialer circular group:
Step
1. Enter system view.
2. Create a dialer interface and
enter its view.
3. Enable traditional DDR on the
interface.
4. (Optional.) Configure the
interface to authenticate the
caller.
5. Return to system view.
6. Enter physical interface view.
7. Assign the physical interface
to the specified dialer circular
group.

Configuring bundle DDR

Configuring a dialer interface to place calls

To configure a dialer interface to place calls, enable DDR and configure a dial string to reach the remote
site. Only one dial string can be configured for each dialer interface.
At the initiator end, the system determines which dialer interface to use according to the dialer-group
rule command configuration. The physical interface uses the configuration of the selected dialer interface
to place calls.
The initiator end can optionally authenticate the receiving end. To authenticate the receiving end,
configure PAP or CHAP authentication on the dialer interface.
Command
dialer route ip next-hop-address
[ mask network-mask-length ]
[ vpn-instance vpn-instance-name ]
[ broadcast | user hostname ] *
Command
system-view
interface dialer number
dialer circular enable
dialer route ip next-hop-address
[ mask network-mask-length ]
[ vpn-instance vpn-instance-name ]
[ broadcast | user hostname ] *
quit
interface interface-type
interface-number
dialer circular group number
180
Remarks
To receive calls from multiple
remote sites, configure this
command multiple times.
You must specify the user hostname
option when configuring this
command.
Remarks
N/A
N/A
By default, traditional DDR is
disabled on an interface.
To receive calls from multiple
remote sites, configure this
command multiple times.
You must specify the user hostname
option when configuring this
command.
N/A
N/A
By default, a physical interface
does not belong to any dialer
circular group.
Make sure the number arguments
in the interface dialer and dialer
circular group commands use the
same value.