HP MSR Router Series Wan Access Configuration Manual page 21

Step
4. (Optional.) Configure a PPP
address pool route.
5. Enter interface view.
6. Configure the interface to assign
an IP address from the
configured PPP address pool to
the peer.
7. Configure an IP address for the
interface.
To configure the device as the server (Method 2: Specify a DHCP address pool):
Step
1. Enter system view.
2. Configure DHCP.
3. Enter interface view.
4. Configure the interface to assign
an IP address from the
configured DHCP address pool
to the peer.
5. Configure an IP address for the
interface.
To configure the device as the server (Method 3: Associate a PPP address pool with an ISP domain):
Command
ppp ip-pool route ip-address
{ mask-length | mask }
[ vpn-instance vpn-instance-name ]
[ vsrp-instance
vsrp-instance-name ]
interface interface-type
interface-number
remote address pool pool-name
ip address ip-address
Command
system-view
•
If the server acts as a DHCP
server, configure the DHCP
server and a DHCP address
pool on the server.
•
If the server acts as a DHCP
relay agent, configure the
DHCP relay agent on the
server, and configure a DHCP
address pool on the remote
DHCP server. In addition, you
must enable the DHCP relay
agent to record relay entries,
and configure a DHCP relay
address pool.
interface interface-type
interface-number
remote address pool pool-name
ip address ip-address
12
Remarks
By default, no PPP address pool
route exists.
The destination network of the
PPP address pool route must
include the PPP address pool.
N/A
By default, an interface does not
assign an IP address to the peer.
By default, no IP address is
configured on an interface.
This command is optional when
the PPP address pool has been
configured with a gateway
address.
Remarks
N/A
For information about
configuring DHCP, see Layer 3
IP Services Configuration Guide.
N/A
By default, an interface does not
assign an IP address to the peer.
By default, no IP address is
configured on an interface.