HP MSR Router Series Wan Access Configuration Manual page 126

Step
6. (Optional.) Exclude the LLC
information element from the
outgoing SETUP message.
(Optional.) Exclude or
7.
ignore the sending complete
indication for call setup.
8. Set the value of an ISDN L3
timer.
9. Set the number type and
numbering plan
identification for calling
numbers or called numbers.
10. Enable overlap sending for
called numbers.
11. Configure ISDN to include
the calling-name field in
outgoing packets.
12. Configure ISDN to include
the connected-name field in
outgoing packets.
13. Configure the ISDN interface
to interpret the PROGRESS
message as the ALERTING
message.
14. Set the progress description
in the progress indicator
information element of ISDN
signaling messages.
Command
isdn ignore llc
isdn ignore sending-complete
[ incoming | outgoing ]
isdn l3-timer timer-name
time-interval
isdn number-property
number-property [ calling |
called ] [ in | out ]
isdn overlap-sending [ digits ]
isdn carry calling-name
isdn carry connected-name
isdn progress-to-alerting enable
isdn progress-indicator indicator
117
Remarks
By default, all ISDN protocols except
5ESS and QSIG include the LLC
information element in the SETUP
message.
The lower layer compatibility (LLC)
element provides low layer
compatibility check information for
the called party. The called party will
reject the call setup request if it
detects an incompatibility.
By default:
•
The device checks incoming
SETUP messages for the sending
complete indication.
•
The device includes a sending
complete indication in outgoing
SETUP messages.
The default ISDN L3 timer values vary
by ISDN protocol. For the default
timer values, use the display isdn
parameters command.
By default, the system automatically
selects a number type and numbering
plan appropriate to the upper-layer
service.
By default, en-bloc sending is
enabled for called numbers. In the
SETUP message, ISDN includes all
information required by the network
to process the call.
If overlap sending is enabled, called
number information is absent or
incomplete in the outgoing SETUP
message.
By default, ISDN does not include the
calling-name field in outgoing
packets.
By default, ISDN does not include the
connected-name field in outgoing
packets.
By default, this function is disabled.
By default, ISDN uses the progress
description assigned by the
upper-layer voice service.